Whelen Strobe install inside the Red Rudder Cap

From Bondline
Revision as of 17:18, 21 January 2009 by Hortonjf (talk | contribs) (New page: == Whelen Flashing Strobe Install == I had already installed the Red Rudder Cap using the original light fixture. When the power supply went bad it was time to upgrade to the Whelen Strob...)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Whelen Flashing Strobe Install

I had already installed the Red Rudder Cap using the original light fixture. When the power supply went bad it was time to upgrade to the Whelen Strobe for the rudder cap.

Whelen parts: Model A 625 strobe light assembly. Model HTS,CF strobe power supply. Model HS-5 Whelen installation kit/wiring harness.

The install is straight forward however the rudder will need to be rebalanced. The Maintenance Manual covers this well.

A bracket to mount the A 625 light will have to be fabricated as well as the HTS,CF power supply. I used the dimensions outlined on the sketch to make the bracket. As indicated a slot will have to be cut on the rear side of the bracket to allow the wiring harness to pass through.

Retrieved from "https://bondline.org/index.php?title=Whelen_Strobe_install_inside_the_Red_Rudder_Cap&oldid=2976"